DIAMANTE MTB HANDLEBAR

darimo-carbon-handlebar-carbon-mtb-flatbar-9-318-mm-ud-matte-black~3.jpg
darimo-carbon-handlebar-carbon-mtb-flatbar-9-318-mm-ud-matte-black~2.jpg
darimo-carbon-handlebar-carbon-mtb-flatbar-9-318-mm-ud-matte-black~3.jpg
darimo-carbon-handlebar-carbon-mtb-flatbar-9-318-mm-ud-matte-black~2.jpg

DIAMANTE MTB HANDLEBAR

320.00
LENGTH:
ANGLE:
Quantity:
Add To Cart

DIAMANTE FLAT HANDLEBAR

Diamante is our lightest products line and probably the lightest on the market. Superlight rims, wheels sets, special parts and components. Handcrafted in Italy with the most advanced technologies, unique finishing and impressive light weight.
Nothing is saddle, we keep developing new products to push the performance a bit higher at every update.  

This type of laminate can be only achieved with a totally handmade construction with a location of the layers of carbon made by hand on each handlebar. There is a different number and arrangement of layers at each point.

The center diameter is 31.8 mm, adapted to the current standards. There are two bend angle options, 6 or 9 degrees. It is manufactured with the desired length of the customer with a maximum of 800mm.

Riders weight limit: This handlebar is safe and has passed the standard ISO 4210 tests, however it is not recommended for more than 198lbs (90kg) riders. In the destructive tests, the handlebar has carried loads of 350 kg without breaking. We can manufacture a custom handlebar without any rider weight limit, increasing 25g only.

Recommended Use: MTB Cross Country and Marathon only.
Finishing: Natural Carbon UD
Bar ends: Not allowed
Clamper: 31.8mm diameter
Angle: 6' or 9'
Length: 740mm / 700mm / 660mm    
Weight: 96g / 89g / 82g
Rider weight Limit: 198lbs (90Kg)

Custom:
For a reinforced handlebar, no weight rider limit, or even exclusive optimization to further reduce weight, contact us and we will produce an exclusive handlebar for you. As it’s produced in a totally manual way, we can adapt to the needs of the users.

 

IMPORTANT NOTICE: The handlebars are calculated exclusively for each width, so a handlebar with reduced width is not a cutted handlebar. This implies a greater work of calculation and manufacture but shorter handlebars have a very low weight.

The central zone (31,8 mm diameter) is 60 mm width. We recomend to use stems with four screws up to 50 mm wide. If you have any doubt contact us.